|
|
| Author |
Message |
hyounce
Newbie Alert
Joined: 20 Jan 2008
Posts: 1
Location: Julian,CA
|
 Posted: Mon Jan 21, 2008 9:24 am Post subject: Impedance Matching |
 |
|
| Just curious. If my amp has both an 8 ohm and a 4 ohm tap on the output transformer, and I elect to hook up both an 8 ohm and a 4 ohm to their respective taps, what impedance load will the amp be looking at? |
|
| Back to top |
|
 |
Structo
Not So Newbie
Joined: 05 Dec 2007
Posts: 8
Location: Orygun
|
| Posted: Tue Jan 22, 2008 10:49 am Post subject: |
|
|
Parallel loads will always be less than the lowest number.
I didn't plug in the numbers you have into a formula but it would be less that 4 ohms. |
|
| Back to top |
|
|
nigelwright7557
Tadpole
Joined: 19 May 2008
Posts: 19
Location: Carlisle, Cumbria, England
|
| Posted: Sat May 24, 2008 4:28 pm Post subject: Re: Impedance Matching |
|
|
| hyounce wrote: | | Just curious. If my amp has both an 8 ohm and a 4 ohm tap on the output transformer, and I elect to hook up both an 8 ohm and a 4 ohm to their respective taps, what impedance load will the amp be looking at? |
Dont do it, your amp is not designed to have speakers connected like that ! You could damage it.
You need to connect speakers in the proper manner of the correct impedance. |
|
| Back to top |
|
|
owwdatune
Moderator
Joined: 08 Jan 2004
Posts: 396
Location: ...on the long and winding road...
|
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
